[tongzilla]

Thanks, the fog is clearing but still a bit of haze. Why the reference to wedges-if a wedge is a static shape but the machine wedges are dynamic? It the intent to maintain one or both wedges?

CW

It's not the size of the Wedges that matter. For example, by changing the amount of Left Wrist Cock I can change the size of my Left Arm Flying Wedge. Or by adjusting my Right Wrist Bend, I change the size of my Right Forearm Flying Wedge.
The important thing is that the plane of the Flying Wedges remained undisturbed. Otherwise, you get some bent-looking Wedges. For example, if I Bend (4-A-2) my Left Wrist, that will deform my Left Arm Flying Wedge, so it's bad.
The Cocking motion of my Left Wrist is on a vertical plane, but the Bending motion is on a horizontal plane.
The Right Forearm Flying Wedge is on a horizontal plane. So if I make any Vertical motion (Cocking or Uncocking) with my Right Wrist, this will conflict with the plane of my Fight Forearm Flying Wedge.
As you can see, the planes of the two wedges are perpendicular or 90 degrees to each other. And as long as the Left Wrist remain flat, and the Right Wrist remain Level (4-B-1), the Wedges will still have this all-important 90 degree relationship with each other. This is true even if you Cock or Uncock your Left Wrist (keeping the Right Wrist Level, obviously) since this only changes the size of Wedge, but the vertical plane of the Left Arm Flying Wedge remains exactly the same.

Edit: I did a new thread here, and you may find the photos helpful. http://www.lynnblakegolf.com/forum/s...4104#post24104